Introduction
The 2 x 25 gallon multi-engine compressor wash rig (JMP/CFM56/D/4777/C200) comprises two 115 litre
stainless steel pressure vessels mounted on a rigid steel chassis, supported by three heavy duty wheels
with 16" super elastic tyres, one of which is mounted on a heavy duty steering castor unit. A drawbar,
which can be locked in the upright position for storage and safety, is attached to the steering castor unit
with a drawbar operated parking brake acting on the front wheel when locked in the upright position.
Each tank is fitted with a filler cap, gauze strainer, pressure gauge, sight glass, pressure relief valve,
3⁄4" BSP drain valve and a 6kW immersion heater.
A 3⁄4", 20 ft long, outlet delivery hose is stowed on the right side of the rig as viewed from the front, with a
1⁄2", 20 ft long, outlet delivery hose, together with a 1⁄4", 20 ft long blow-off hose in the rear storage box for
clearing the sensing tubes/hoses after a wash. Rubber protective collars are installed on the end of each
hose to protect the couplings from damage.
Operation
The fluid in the tanks is pressurised by two rechargeable onboard nitrogen cylinders (a MS28889-2 Schrader
charging valve is fitted to the rig for in-situ recharging) controlled by a regulator and distributed to the top
of each pressure vessel via a nitrogen inlet manifold. There is also an optional Air Inlet Kit
(JMP/CFM56/D/6612) available to enable the connection of offboard compressed air or nitrogen if required.
Once pressurised, the fluid is forced up the outlet stack pipe to the appropriate fluid outlet isolation ball
valve. From there it is directed through the filter, to the 3-way engine selection ball valve, which controls the
output to the appropriate tooling via the outlet hose connection to the twin hose assembly.
The rig has two 6kW immersion heaters (one for each pressure vessel) requiring a 115V/200V,
3-phase, 400Hz electrical power supply to heat the tanks to a temperature of 700c in one hour. The
necessary power is supplied from a ground power unit (GPU) or hangar power supply. A 24V battery
installed in the rig's electrical enclosure provides the power required for the interlock (necessary for the
power to connect) to operate.
Rig Variations
These specifications apply to rigs constructed from 2008 onwards. Specifications on earlier rigs may differ.
All rigs now feature the 115V/200V, 3-phase, 400Hz electrical system unless otherwise requested. When
ordering one of these rigs, every effort will be made to accommodate any modifications required, please
contact us for details.
Size: (L) 2515mm x (W) 1067mm x (H) 1296mm Weight: (Dry) 352Kg
Packing crate dimensions: (L) 2642mm x (W) 1093mm x (H) 1524mm Weight: (Gross) 601Kg